New Holland 8002: Low Voltage at Load Clamp Input Pin

The MCC1 controller detects a voltage level at the load clamp input pin that is below the minimum threshold of 9.8 volts. This may affect the proper operation of the system connected to the load clamp input.

1. 1

   Voltage at the load clamp input pin

2. 2

   Connections to the load clamp input pin

3. 3

   Power supply to the MCC1 controller

1. 1

   Verify

   Measure the voltage at the load clamp input pin using a multimeter to confirm the reading is below 9.8 volts.

2. 2

   Inspect

   Check the wiring and connections to the load clamp input pin for any damage, corrosion, or loose contacts.

3. 3

   Test

   Test the power supply to the MCC1 controller to ensure it is providing stable and sufficient voltage.