8006

New Holland 8006 – Front PTO: Low Side Driver Stuck On, No Current Sensed

Issue description

The Front PTO controller has detected that the low side driver (switch) responsible for activating the Front PTO solenoid is electrically closed or 'stuck on' despite being commanded open. Simultaneously, the controller detects no electrical current flowing through the circuit. This contradictory state points to a likely open circuit in the wiring or a failure within the solenoid itself, as the controller expects to see current draw when the driver is active.

Applies to these machines

  • T8.275
  • T8.300
  • T8.320
  • T8.330
  • T8.350
  • T8.360
  • T8.380
  • T8.390
  • T8.410
  • T8.420
  • T8.435
  • T7000 Series
  • TM Series

Check the cause

  1. Visually inspect the wiring harness leading to the Front PTO solenoid for chafing, breaks, or corrosion on the connectors

  2. Check all fuses related to the PTO and transmission control systems to rule out a low voltage supply issue

  3. Verify power at the solenoid by checking for 12V at the electrical connector with the PTO switch engaged

  4. Test the solenoid coil resistance using a multimeter (expected value is between 6 and 11 ohms)

Repair steps

  1. Isolate the fault

    Disconnect the electrical connector at the Front PTO solenoid to begin testing the circuit.

  2. Test and replace solenoid

    Measure the resistance of the solenoid coil. If the resistance is outside the 6 to 11 ohms specification or shows an open circuit (infinite resistance), replace the faulty solenoid.

  3. Inspect and repair wiring

    If the solenoid tests within specification, thoroughly inspect the wiring harness between the Front PTO controller and the solenoid. Check for continuity on the signal wire and repair any open circuits, shorts to ground, or damage.

  4. Replace Front PTO controller

    If both the solenoid and wiring are confirmed to be in good condition, the low side driver circuit within the Front PTO controller has likely failed. Replace the controller.

Parts you might need

(17)
  • Front PTO Solenoid / Electro-Valve

    87640495

    For T8 Series

  • Listed as 'ELECTRO-VALVE' in a T8.360 parts diagram

  • General New Holland Solenoid Valve

  • Front PTO Solenoid / Electro-Valve

    QTP-43758

    Multi-function solenoid listed for T8/TG series tractors

  • Front PTO Assembly

    84474187

    For T8 Series (replaces 87056348, 86539411)

  • Front PTO Assembly

    856621

    For T8 Series

  • Front PTO Assembly

    47467276

    Front Linkage + PTO by Zuidberg for T8 Series

  • General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • Front PTO Control Module

    81864314

    General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • Front PTO Control Module

    81867013

    General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • Front PTO Control Module

    F0NN94044N90AA

    General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • Front PTO Control Module

    F0NN94044N90BA

    General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • General New Holland (for models 5640, 6640, 7740, 7840, 8240, 8340)

  • Example part number. Alternatives include 84273815, 87472229, 9844156. Verify exact fitment by serial number.

  • Front PTO Control Module

    82011707

    Example part number. Alternatives include 81869818, 81864314, 81867013, F0NN94044N90AA. Verify exact fitment by serial number.

  • Front PTO Control Support

    5177068

    Verify exact fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other New Holland codes