New Holland 9158 – UCM: H Pattern Indicator Shorted To Ground White
Issue description
The Universal Control Module (UCM) has detected a short to ground in the electrical circuit for the H-Pattern indicator light, specifically on the white wire. The H-Pattern indicator displays the active joystick control scheme for drive functions. This fault signifies an electrical failure within the indicator circuit, not a mechanical issue with the controls themselves.
Applies to these machines
14 machines- L213
- L215
- L218
- L220
- C227
- C232
- C238
- 300 Series
- SR220
- SR250
- SV250
- SV300
- TR320
- TV380
Check the cause
Visually inspect the wiring harness leading to the control pattern selector switch and the instrument panel indicators. Look for any signs of damage, such as chafing, cuts, or corrosion, particularly on any white wires.
Check for other active fault codes (such as 5701 or 9160) that may provide additional context.
On machines with electro-hydraulic (E-H) controls, attempt to switch between ISO and H-pattern modes to see if the switch itself is functioning. Note any unusual behavior on the display panel.
Check relevant fuses for the instrumentation and control modules.
Repair steps
Disconnect battery
Before beginning any electrical work, disconnect the battery to prevent electrical shock or further damage.
Access components
Gain access to the rear of the instrument cluster/panel where the indicator lights are located, and to the control pattern selector switch if separate. This may require removing panels in the operator's cab.
Disconnect connectors
Disconnect the electrical connector from the H-pattern indicator light and the control pattern selector switch.
Test indicator circuit
Using a multimeter set to measure resistance (Ohms), check for continuity to ground on the white wire at the indicator light connector. A reading of very low resistance (close to 0 Ω) confirms a short to ground in the wiring harness between the control module and the light.
Locate the short
If a short is confirmed, carefully trace the white wire from the indicator light back towards the Universal Control Module (UCM). Pay close attention to areas where the harness passes through the chassis, is secured by clamps, or may come into contact with moving parts. Flex and manipulate the harness while monitoring the multimeter to see if the short appears or disappears, which can help pinpoint the location of the damage.
Repair or replace wiring
Once the damaged section of the wire is found, repair it using appropriate splicing and heat-shrinking techniques to ensure a durable and insulated connection. If the harness is extensively damaged, replacement may be necessary.
Test indicator and UCM
If the wiring harness tests clear of any shorts, the issue may lie with the indicator light itself or the control module's output. A faulty LED or bulb assembly could potentially short internally. A failure in the UCM's driver circuit for that indicator is also possible, though less common. In this case, further diagnostics with a specialized tool may be required to test the UCM output.
Reassemble and verify
Once repairs are complete, reconnect all electrical connectors and reassemble the panels. Reconnect the battery and turn the ignition on. Clear the fault codes using a diagnostic tool or the onboard procedure. Operate the machine and switch between control patterns to verify that the H-pattern indicator light functions correctly and that fault code 9158 does not reappear.
Parts you might need
(3)- Indicator Light87722267
Generic New Holland indicator light; specific application not confirmed. Verify fitment with machine serial number.
Control Pattern Selector Switch
Specific to machine model; verify through dealer.
Wiring Harness
Highly specific to machine model and configuration.
Get help to fix this fault by requesting a quote