New Holland E117: Cutting Speed Sensor (B10) Short Circuit to PLUS

A short circuit has been detected in the Cutting Speed Sensor (B10) circuit, specifically to the PLUS voltage supply. This fault may affect the proper operation of the sensor and the system relying on its input.

1. 1

   Cutting Speed Sensor (B10) wiring

2. 2

   Connections to the Cutting Speed Sensor (B10)

3. 3

   Power supply to the Cutting Speed Sensor (B10)

1. 1

   Inspect

   Inspect the wiring and connections of the Cutting Speed Sensor (B10) for signs of damage, wear, or improper routing.

2. 2

   Test

   Test the voltage supply to the Cutting Speed Sensor (B10) to ensure it is receiving the correct PLUS voltage.

3. 3

   Repair

   If a short circuit is found, repair or replace the affected wiring or connections as needed.