New Holland TMF 106 – TMF: Aux 5th remote valve control switch (Extend) is failed in the Armrest Controller

The TMF controller has received data from the electro-hydraulic #5 control extend switch indicating that it is in an error state.

• T8040
• T8010
• TG215
• T9 Series
• T9000 Series
• CR9090
• CX8080 Elevation
• CX8090 Elevation
• MXM/TM series
• Steiger

1. 1

   Inspect the Aux 5th remote valve control switch (Extend) on the armrest for physical damage or sticking.

2. 2

   Check the electrical connections and wiring harness between the armrest controller and the TMF controller for shorts or open circuits.

3. 3

   Verify if the switch data remains in the error state using a diagnostic tool.

1. 1

   Access armrest controller

   Access the armrest controller pod where the electro-hydraulic remote valve switches are located.

2. 2

   Inspect switch and wiring

   Inspect the specific Aux 5th remote valve switch and its wiring connections.

3. 3

   Test switch

   Test the switch for proper operation.

4. 4

   Replace switch or controller

   Replace the faulty remote valve toggle switch or the entire armrest controller unit if the switch is integrated and cannot be replaced independently.

5. 5

   Clear fault codes

   Clear the fault codes from the system.