This finger holder secures the pickup finger in the header of a grain combine or forage harvester. It positions the finger within the drum or auger assembly so the finger can retract and extend at the correct timing to feed crop material onto the conveyor. A worn or broken holder allows the finger to shift, causing uneven crop flow and potential damage to the drum or auger trough. As an original AGCO component, the holder is machined to the same bore diameter and finger-mounting diameter as the original assembly, so the finger pivots freely without binding or excessive play. On installation, verify that the retaining hardware is tightened to the specified torque and that the finger rotates smoothly through its full cycle before closing the header.