John Deere fault codes

Reel Fore/Aft Diverter Not Responding to Command

Left Rear Discharge Light Not Activating as Commanded

Precleaner 1 Open Status Does Not Match Command

RCU PTC power out of range - less than 4.0 VDC

Alternator Field Not Activated as Commanded

Precleaner Open Switch Voltage Exceeds 4 VDC for Over 30 Seconds

Right sieve actuator failed calibration with pulses present on sieve 2 position

Left Chaffer Actuator Failed Calibration

LPC2 power 4 (cc#262) is less than 4.5 VDC at the left power module 1 input

Faulty Driver for Reel Reverse Solenoid

Main gearcase filter issue detected when engine is not running

Precleaner Actuators Not Calibrated

Folding Unloading Auger Position Sensor Not Calibrated

Deck Plates Detected Without Calibration

Precleaner 1 and Precleaner 2 Actuators Not Synchronized

Folding Auger Position Calibration Voltage Out of Range High

Deck Plates Sensor Voltage Too High

Coolant Temperature Input Voltage too High

Deck Plates Sensor Voltage Too Low

Coolant Temperature Input Voltage too Low